Programs
 
  1. demo.html - The "demo_sim" program used in the Code Warrior assembly tutorial. This very simple absolute assembly program just adds two numbers and stores the result in memory.
  2. demo2.html - The "demo2_sim" program used in the Code Warrior stationery tutorial. It is a very simple program based on "demo_sim", but in addition lights some LEDs to match the binary  pattern of the sum of two numbers.
  3. hola_ep.html - Simple Dragon12 program using the DBug12 'printf' routine and Hyperterminal. Written using Code Warrior.
  4. string2lcd.html Program - Code Warrior/Dragon12 program that converts a 16 bit signed/unsigned number to the decimal ASCII equivalent, and displays the converted result on the CRT in a Hyperterminal session (using the DBug12 'printf' routine).
  5. string2lcd.html Program - Code Warrior/Dragon12 program that demonstrates how to print strings to lines 1 and 2 of the LCD.
  6. mc9s12dp256.h - Motorola-supplied header file for use in Code Warrior C programs.
  7.  Reg9s12.h- Assembly header file for all the registers in the HCS12/Dragon12.
  8. _ee3376sim.zip - this is a zipped file containing the stationery for cases when both hcs12 hardware and Simulator targets are needed. Unzip and install in a folder called "_ee3376sim" in your HCS12 Stationery folder (which is in your base Metrowerks installation).
  9. _ee3376.zip- ditto but for the case when only the hcs12 hardware target is needed.
  10. _ee3376_C.zip - this is a zipped file containing the stationery for cases when using the C programming language. Unzip and install in a folder called "_ee3376_C" in your HCS12 Stationery folder (which is in your base Metrowerks installation).
  11. Ep9s12_mon.s19 - DBug12 monitor program (for use when re-flashing DBug12 on the Dragon12 in case it was erased or corrupted). Download this file and load it into Flash using the serial monitor *Ep9s12_boot.s19 bootloader), which is automatically run when sw7 is set to "bootload" mode (sw7 = 1/1 or up/up).*  - Serial monitor program (bootloader) for Flashing the Dragon12. This program must be Flashed in via BDM.
  12. SRecCvt.exe - DOS executable for converting s-records into a format suitable for the serial monitor (bootloader) when Flashing the memory. See the SRecCvtRG.pdf guide for further information on using SRecCvt.exe for converting S-records.
 
 
 
EE3376 Programs